ASK Tools

All the essential tools for anyone starting out woodturning a 6 piece HSS starter chisel set, 6" bench grinder to keep them sharp, a CWA100 heavy duty revolving centre and a CWA61 2 1/2" screw chuck.

A versatile screw chuck that can also be used as a small face plate. fits 3/4 x 16 tpi only

A small screw chuck for light work will hold up to a 7" bowl fits 3/4 x 16 tpi only

4" Cast iron face plate for large bowl work suitable for use up to 16" in diameter fits 3/4 x 16 tpi only

6" Cast iron face platefor large bowl turning siutable for up to 30" blanks Fits 3/4" x 16 tpi only.

4" Cast iron face plate for large bowl work suitable for use up to 16" in diameter fits 1 1/"4 x 8tpi

6" Cast iron face plate for large bowl work suitable for use up to 16" in diameter fits 1 1/"4 x 8tpi

Drill chuck and a 1MT arbor, designed to operate in both the tail staock and the head stock. Used with standard boring bilts and expansive cutters

large drill chuck and arbor, the chuck is threaded to 3/4 x16 tpi and will fit direct on to the head stock of lathes with this fitting or can be used in the tail stock with the 1 MT arbor. Used for boring with standard boring bits and drills.

large drill chuck and arbor, the chuck is threaded to 3/4 x16 tpi and will fit direct on to the head stock of lathes with this fitting or can be used in the head stock & tail stock with the 2 MT arbor. Used for boring with standard boring bits and drills.

Large 4 prong drive 7/8" diameter to give extra grip in large section timbers 1 morse taper

the 2 prong drive is for turning wet and out of balance wood, the 2 prongs allow extra penetration of the drive centre. 1 Morse taper 5/8" diameter

Standard live centre, eliminates the scorching of timbers from fixed centres, the sealed for life bearings resist sideways and downward pressures.

Designed for use with large and heavy timbers fitted with high quality bearings it resists sideways and downward movement of timbers 1 morse taper

Complete with CWA92 cup Centre, counter boring tooland a CWA111  5/16" x 30" shell auger. Siutable for use on all Record Power lathes and other 1 morse taper lathes.

Complete with CWA92 cup Centre, counter boring tooland a CWA111  5/16" x 30" shell auger. Siutable for use on all lathes with a 2MT taper.

5/16" x 30" Shell auger for use with CWA131 long hole boring kit, allows boring holes up to 40" between centres

Tail stock center with removable inner for use with 5/16" shell augers and long hole boring, 1 morse taper.

17" tool rest for use when turning long spindles please note this rest has twin stems and requires an additional banjo assembly CLO/L

10" Tools rest with 19mm diameter stem for all CL series lathes