Woodturning DVD's

Woodturning DVD's from Record Power

 

!

RPDVD07
!
Woodturning Projects - Mantle Clock
Alan shows you how to work accurately on relatively small scale pieces and leads you confidently through the potentially difficult techniques of dividing out and angle drilling to produce elegant finished products.
The tuition will provide a sound base for developing your own projects and designs.

RPDVD09
!
Woodturning projects - Wall Clock
Alan shows you how to work accurately on relatively small scale pieces and leads you confidently through the potentially difficult techniques of dividing out and angle drilling to produce elegant finished products.
The tuition will provide a sound base for developing your own projects and designs.

RPDVD08
!
Woodturning Techniques - An introduction to bowl turning
In this range of DVD’s Alan Holtham uses simple projects to demonstrate sound techniques enabling the novice turner to easily and quickly achieve accomplished turnings. Alan starts right at the beginning showing you how to actually mount the wood in the lathe. The whole project is turned using four basic tools, Alan emphasises that the beginner only needs these few essentials to get started, keeping it as simple as possible whilst you build confidence. Each tool is shown working in detail, with clear instruction about the presentation angle and tool movement to produce clean cuts that require the minimum of work to finish with abrasive paper.

RPDVD06
!
Woodturning Techniques - An Introduction to Spindle Turning
In this range of DVD’s Alan Holtham uses simple projects to demonstrate sound techniques enabling the novice turner to easily and quickly achieve accomplished turnings. Alan starts right at the beginning showing you how to actually mount the wood in the lathe. Alan emphasises that the beginner only needs these few essentials to get started, keeping it as simple as possible whilst you build confidence. Each tool is shown working in detail, with clear instruction about the presentation angle and tool movement to produce clean cuts that require the minimum of work to finish with abrasive paper.

RPDVD05
!
Step By Step Guide - Finishing On The Lathe
In this programme Alan Holtham demonstrates two different techniques for finishing work on the lathe.
Achieving a good finish is perhaps the most important part of the making process, but it is one that is often rushed by the turner, spoiling what would otherwise have been a nice piece of work.
All techniques are shown in real time so you see exactly how it is done.